五星級標識牌沖刷時間的長短就決定了標牌字的蝕刻的深度。

    在標識牌制作時的一些提示：如果蝕刻太深，要提高傳送帶前進速度：如果蝕刻太淺，要降低傳送帶前進速。
    在我們制作標識牌的時候大約3分鐘后， 我們可在出料口拿到試刻的不銹鋼板，用手試摸一下蝕刻的深淺程度,如果手指上感到有點高低的感覺，這時的深度在大概在0.1毫米，就可以開始正式蝕刻。這是制作標識牌的基本原測.

    標牌的作業正式蝕刻在這里開始。
    創意分業的工作就是這里的時候，把堅好膜 五星級標識牌并在反面貼上了防腐保護膜的那二塊不銹鋼板放在入料口的合適位置，按下蝕刻開關，蝕刻機就開始對不銹鋼板進行蝕刻， 3分鐘后，我們就在出料口看到了的這兩塊不銹鋼板，仔細檢查一下，像這樣就達到了我們要求的蝕刻效果。我們標識牌的沖刷時候就需要非常好的師付來解決這一個問題。
 
Identity cards washed the length of time will determine the depth of etching the word sign.

     When the identification card production are some tips: If etched too deep, to raise the conveyor speed ahead: If etched too shallow, to reduce the forward speed conveyor belt.
     Production of identity cards in our time about 3 minutes later, we can try to get the discharge port of the stainless steel plate engraved, hand touch etching test the degree of difficulty, if the fingers are feeling a bit low, then the depth of the about 0.1 mm, we can officially etching. This is a production of the basic principles of measuring signage.

     Sign etched on the job officially here.
     Creative sub-sector job is here, a good film and the strong negative labeled anti-corrosion protective film that two stainless steel plate on the right into the discharge port position, press the switch etching, etching machine began to stainless steel etching, 3 minutes later, we saw the spout of which two stainless steel plates, carefully check, so as to meet our requirements etching effect. The erosion of our identity card when you need a very good teacher pay to solve a problem.